(800) 853-2651
SHOP NOW

Press in great retainers

D

Don E. Foster

Member
Where, oh where, can I find the press in grease retainers. I have am Allis-Chalmers WD, single front. I changed the tire and checked the bearings but the grease retainers are shot. 2.25" with 1.5" shaft. That damned wheel is heavy. Let the air out of the tire but that didn"t help a bit!!!

One day at a tire shop I told the lady I had to let the air out because it had 50# air and that made it lighter. Boy, did I ever get a scientific lecture!!! But...it was her 15 minutes of fame.
 
Are you joking about the tire air pressure? I hope you are.. because air isn't much heavier than air when it's compressed.. it has no real mass.
 
Try a good parts store,Abearing supply store atractor dealer,take the old seal with you and let them measure it for cross over number. O by the way put the air back in the tire but be sure it is hot ,because hot air is lighter.
 
You must log in or register to reply here.

Similar threads

N
Galion 104H
Replies
10
Views
529
Nolbyone
N
jd2cyl1943
Here's the story of my JD Bs restoration up to this poi
2
Replies
26
Views
2K
jd2cyl1943
jd2cyl1943
jd2cyl1943
The story of my Bs restoration up to this point.
Replies
6
Views
923
jd2cyl1943
jd2cyl1943
W
Allis Chalmers WD -- Knoedler Seat Rebuild -- Pictures!!
Replies
14
Views
2K
Will Herring
W
R
Maybe it was a bargain after all.
Replies
5
Views
868
J.Wondergem
J.Wondergem
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top