(800) 853-2651
SHOP NOW

Massey 1100

K

Kevin Mosley

New User
I am looking at a Massey 1100. The guy that has it now says everything was running fine and then all of a sudden he lost all hydraulics, power steering, and brakes. Anybody got any idea what may have happened? Any ideas would be greatly appreciated.
 
It has been 20 years ago but I remeber a dump valve on the floor, for ease the starting I think it looked like a pin with a keyring on it up dumped hyd' pressure and down for run.
 
Probably has a pto shaft on the back of the engine that goes into a pto hub. Sometimes they strip the splines off and no more hyraulics. It just looks like an axle shaft out of a car. I just changed one on a White about a month ago.
 
It looks like a key ring and is located strait down as you are looking between your legs while sitting on the seat. If the floor get's real muddy it will pop up when you step on the ring. Hope it's only that otherwise $$$.

Good Luck
Merle
 
One of four things:

Either the 5 micron filter behind the grill is plugged. OR

The metal filter screen in the bottom of the transmission housong is plugged. OR

Most likely, the charge pump under the platform failed. Either the key broke, shaft failed or other internal failure.

Radial pump failure. Though not common, still possible.
 
I would bet that the problem is the coupler on the pto shaft between the transmission & rear end. When it goes bad you loose all hydralics instantly. It could also be the coupler in the flywheel.
 
Yes, on a Massey, if you lose hydraulics, you lose everything (steering, brakes, etc.)
My 1130 did the same thing this summer. It was the coupler under the platform... For a $25 dollar part, labor was around $600 for the install (you have to take the top of the platform off, etc.)
 
You must log in or register to reply here.

Similar threads

D
JD 1520 Independent PTO problem
Replies
7
Views
452
Jim.ME
J
S
Need a year model for Massey Ferguson
Replies
8
Views
592
Sarai7
S
M
Massey 302 industrial with 300 loader will a 220 backhoe work?
Replies
1
Views
238
Mysteree11
M
B
4240 powershift lost all gears
Replies
10
Views
683
buickanddeere
B
Turkeyfoot
Ignition switch 0n 83 mustang GT
Replies
16
Views
645
BarnyardEngineering
BarnyardEngineering
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top