WD 45 Allis Chalmers Hydraulic

Anonymous-0 · Nov 17, 2008

My WD45 has lift arms to handle round bales of hay. Sometimes it will lift with no problem other times only 6" off groung. Hydraulic reservoir is full. I tested pressure with a gauge and sometimes it is between 2500 - 3000 psi and other times not over 1500 psi. Are the linkage adjustments incorrect or what else may be the problem?

Mr. Ed · Nov 18, 2008

When you go to push up the lift lever do it very easily. Tractor engine doesn't need to be wide open either,maybe half throttle. With time you'll figure things out.

NEKS · Nov 18, 2008

I had some 3 point arms(lower arms) that fastened to the drawbar bale underneath. Sometimes would lift a bale other times not. Extended them on down to the pin(on WD)or the snap coupler bell on WD45 and you can lift twice as much without a problem. These are close 1000 lbs bales.

WD 45 Allis Chalmers Hydraulic

Anonymous-0

Well-known Member

Mr. Ed

Member

NEKS

Well-known Member

Similar threads