Hey folks I have a Massey Ferguson 65 with power adjust wheels and I need a rim. It has 11x28 on it now, I found a guy close to me that has a set of 12x28 from an Allis Chalmers. My questions are will they fit my center dish? Is the angle of the rail to the rim the same? Do the blocks swivel to align themselves? I don't want to buy these if they are't going to fit.
- Thread starter JDMAN60
- Start date
Anonymous-0
Well-known Member
Smaller wheels, like 26-30 inch, typically have 4 rails per wheel. 36-38 inch will have 6 rails per wheel. On the AC, the blocks fill in the space between the eccentric bolt, and the rail. Swivel is not an issue- they are held in place by the casting that bolts to the dish.Measure the height of the rails on each- you could also measure the angle, but I'll bet they are about the same. Length of rail will dictate how much the wheels adjust, as long as the angle is the same. I think on narrow rims, like 11 inch, there is more overlap to the outside- ie- same length rail on both 11 and 12 inch rims? Check the Steiner website- if they list one rim for each app....should be good to go with your friend's rim.
Anonymous-0
Well-known Member
Is the 12 inch the tire size or rim size? Standard on a WD was 11x28, oversize was 12x28, but could fit on the same rim. What is the actual rim width?
Anonymous-0
Well-known Member
The holes for the wheel stops may be different. Some are drilled straight, some are drilled at an angle.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy