(800) 853-2651
SHOP NOW

Corn Head Stripper Plates

If you set them at 1 1/8 front and 1 1/4 rear it will work fine and not lose ears or plug with stalks . Just dont try to set them with the front inverse or you will plug constantly.
 
You must log in or register to reply here.

Similar threads

P
Ferguson D-PO-10
Replies
3
Views
331
Mickey Keener
M
Majorman
Sunday Stripper
Replies
0
Views
162
Majorman
Majorman
P
Seed plates for D-PO-10
Replies
0
Views
102
PatMcKeague
P
T
Correct corn plate for JD 7000?
Replies
7
Views
919
Tree-Farmer
T
T
27V MOWER
Replies
5
Views
381
steve_in_mo
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top