Had to replace the radiator in my Ford 3600 (due to axle pin coming out, previous post) got the correct one (from company on this site) all look good except that the shroud does not attach. Old Radiator was 19 inch across top and 18 1/2 on bottom. New radiator is reversed. Needless to say the bottom being too wide is the issue. Not sure what to do, I don’t have any way to fabricate new shroud or brackets and I know you have to have the shroud or it wont cool right. The shroud feels and looks like plastic (sure it’s not but it something like that). Only thing I can come up right now is trying to heat it up and bend it a little (but not sure if you can do that)? any suggestions or words of wisdom would be greatly appreciated. Thanks