Anonymous-0
Well-known Member
Good Day: Hopefully this is the right forum for this... Problem is this i have a Woods HSS72 mower, and the right side decking is now cut through for about 4 ft or so with a nice blade circle around the top.
One end of the crossbar that the blades hook onto is bent upward.
The question is the idea of heating it in a forge and straigntening the crossbar end, will it have any strength to stay straight? bite the bullet and get new?
The bend is at the section where the blade pin goes through, basically a piece of heavy flatbar it looks like, but better quality than normal.
whats the thoughts.
thanks
One end of the crossbar that the blades hook onto is bent upward.
The question is the idea of heating it in a forge and straigntening the crossbar end, will it have any strength to stay straight? bite the bullet and get new?
The bend is at the section where the blade pin goes through, basically a piece of heavy flatbar it looks like, but better quality than normal.
whats the thoughts.
thanks