(800) 853-2651
SHOP NOW

Deutz D -7206

Q

Quietwind

New User
Can anyone help me with valve adjustment procedure and valve clearance specs on the air cooled engine in Deutz D7206.

After extreme difficulty to get it running; it sounds like the valves need major adjustment. Power isn't bad but idle is'nt steady. Before I start pulling injectors and injection pump I would rather check valve adjustments first!

If someone could tell me vbalve clearance spec's at least I might be able figure the rest out. Thanks for your help!
 
engine cold inlet and exhaust valves should be 0.15mm. send me your email and i will send you the diagram/page from manual. I tried to post the photo, if this does not work than just go with sending me your email and i'll send directly to you. Posted in Parts and Pieces/7206 Deutz/Valve Clearance
 
You must log in or register to reply here.

Similar threads

M
Running Rough and I'm out of Ideas
Replies
17
Views
1K
Mnethercutt
M
R
Adjusting the Valves - PLEASE HELP
Replies
13
Views
2K
JMOR
J
S
2020 CB pump reseal
Replies
4
Views
1K
fdt860
F
M
Running Rough and Running Out of Ideas
2
Replies
23
Views
3K
CPeter
C
J
Rebuilt Cat 3204 motor will not start on own power.
2
Replies
30
Views
7K
Nordic
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top