tom levandoski
Member
Where is the best place to get a seal for a 1957 I.H. 450 Hydraulic pump front shaft seal no eligible no. On it?
- Thread starter tom levandoski
- Start date
rustred
Well-known Member
i just gave this info a few days ago to someone here. put the old one in ur pocket and go to motion ind. 780-465-0821 or fluid power 780-
452-1594 both in edmonton ab. thats where i go. they measure them and pick it off the shelf. napa would be doing the same thing just saves
you some money going directly there. or you can measure it with calipers and call in.
452-1594 both in edmonton ab. thats where i go. they measure them and pick it off the shelf. napa would be doing the same thing just saves
you some money going directly there. or you can measure it with calipers and call in.
used red MN
Well-known Member
- Location
- Coon Rapids, MN
Look at subsections 371 and 373 in the Hydraulics
section. You can tell what type of pump you have by its
shape. If you have two different sized seals you must
have a Thompson pump. The back seal number 17
subs to a different part number.. 356887R91 subs to
124633R91
CNHI Farmall 450 online parts catalog
section. You can tell what type of pump you have by its
shape. If you have two different sized seals you must
have a Thompson pump. The back seal number 17
subs to a different part number.. 356887R91 subs to
124633R91
CNHI Farmall 450 online parts catalog
tom levandoski
Member
Thank you for the great info so far!!
tom levandoski
Member
could not find no no. on pump has his TAG M&W GEAR CO WHICH no info on after checking pump looks a little different then those showing.
This post was edited by tom levandoski on 10/12/2023 at 07:46 am.
This post was edited by tom levandoski on 10/12/2023 at 07:46 am.
tom levandoski
Member
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy