HELP 10' kongskilde triple k

Rogerworco · Sep 12, 2023

I have a 10' kongskilde triple k.

The wheels are supposed to raise and lower but the pins are frozen or stuck ....not sure if they screw out or slide out but so far I have not had any luck ...anyone know anything ...see pic .

[/img]

This post was edited by Rogerworco on 09/12/2023 at 06:00 pm.

super99 · Sep 13, 2023

Not familiar with that brand, looks like a depth
adjustment wheel, The circled area looks like a hole to
me, dont see a pin. That said, I doubt the pin is
threaded, most likely rusted in. Use a good penetrating
oil, not WD40 and soak it down good daily and rap it a
few times with a big hammer every day for a week and it
should loosen up Diesel fuel and ATF mixed 50/50 works
good. If that fails or youre in a hurry, heat is your friend.

Millwright · Sep 13, 2023

They are not a through hole, they are a nub that protrudes from the square nut inside for the threaded adjustment, should turn and move up and down easy, if the crank doesn't turn you have a rusted and seized thread.

Rogerworco · Sep 13, 2023

(quoted from post at 06:59:47 09/13/23) They are not a through hole, they are a nub that protrudes from the square nut inside for the threaded adjustment, should turn and move up and down easy, if the crank doesn't turn you have a rusted and seized thread.

So that nub is not a pin and does not come out of unscrew .... ? If the adjustment wont go up and down its because its rusted /frozen on the threads .....correct ?

Millwright · Sep 14, 2023

Yes, nub is part of nut, the assembly will only come apart if you are able to turn the thread and move the channel up, most likely rusted/stuck.

HELP 10' kongskilde triple k

Rogerworco

New User

super99

Well-known Member

Millwright

Member

Rogerworco

New User

Millwright

Member

Similar threads