(800) 853-2651
SHOP NOW

1010/2010 engine swap

H

Herpdawg

New User
Just put a 145 gas engine from a 45 combine on a JD 1010 tractor. Rus pretty good. I put the manifold and carburetor from the 1010 115
engine on the 145. Part book numbers are different for the heads. Carburetors are different. Will it be absolutely necessary to put a 145
tractor manifold and carburetor on this engine. The carburetor linkage on the 1010 is between the carburetor and block and the air intake
runs to the back where on the 2010 it appears to be reversed with linkage on the outside and air intake to the front. Thoughts please.
Thanks
 
Years ago our JD mechanic did that and I don't know if he had to do any changes like that. I have found out the only changes on the engines were the deck plate and pistons and rings and the 165 engine from the combine would also bolt up.
 
Can you combine carbs and put the throttle shaft in the othervway moving linkages back to between carb and block?
 
Thanks for the reply. For now I think I will use the 1010 manifold and carburetor and see what happens. It is not going to be used a bunch anyway.
 
You must log in or register to reply here.

Similar threads

M
Zenith carburetor
Replies
7
Views
442
ken44520978
K
H
JD 145 gas oil pressure issue
Replies
2
Views
300
caterpillar guy
C
M
JD 1010 crawler Carburetor
Replies
3
Views
466
the tractor vet
T
M
Running Rough and I'm out of Ideas
Replies
17
Views
1K
Mnethercutt
M
H
IH574 Gas Tractor with a 3/8" Bolt in the Carburetor Outlet
Replies
9
Views
398
stevieb49829
stevieb49829
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top