Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
Pickup that I use similar to a tractor that I handle rd bales with had check engine light come on today. Engine went into reduced power mode. Then engine wouldn't stop operating when ign switch was turned to off & check engine light stays on after ign switch is turned off then turns off after 10 or 15 seconds. I scanned codes & saw Po222 & Po455. Attempted to start engine & no start. Po222 is accelerator controller & Po455 is evap leak. My truck has a newer fuel cap. Battery tested 12.7 volts & I cleaned both battery cable ends. Still no engine start. Engine won't attempt to start with trans selector in "N" either. I'm guessing faulty wiring connection but I wondered if any member experienced similar electrical problem??
Thanks for any ideas, Jim
Thanks for any ideas, Jim