(800) 853-2651
SHOP NOW

Ford 4000 (pre 1965) (or 801, 901) Gearbox

B

Bill_Adair

New User
Next question :)

My Ford 4000 has the hi / low range Sherman transmission add on.
I can select hi and low but not standard. I discovered the in / out movement shown on the shift diagram but I'm not sure it's moved enough (and isn't moving back as shown to engage std).

I'm assuming it's slightly rusty and want to use the hammer but would like to have confidence the lever is in the right position.

How far does the lever come out?

Bill
mvphoto93741.jpg


mvphoto93742.jpg


mvphoto93743.jpg



This post was edited by Bill_Adair on 06/24/2022 at 03:26 pm.
 
It should go up after you pull it out to the side. But you may need to let the clutch out and back in to line things up to do so or if it hasn't been used in a long time it maybe stuck. Also one thing that doesn't help is if it is low on oil so you need to check the oil lever in your transmission
 
It worked!!!
My mower will be very happy to get 540 rpm at last.
Nothing is more confusing that the Ford gate pattern and the hi, low, std box (and coming off a Massey 165 where 1st gear means "very, very slow indeed")....

Thanks everybody.

This post was edited by Bill_Adair on 06/26/2022 at 08:39 am.
 
You must log in or register to reply here.

Similar threads

B
Ford 4000 (pre 1965) (or 801, 901) Foot Pedal
Replies
1
Views
455
NIK OWEN
N
D
Massey Ferguson 1105 PTO how to engage ?
Replies
4
Views
1K
Dieselmad
D
J
Help deciding first project - Ford 9N vs Allis-Chalmers
2 3
Replies
40
Views
3K
rustred
rustred
W
'66 4000 SOS PTO issue
Replies
6
Views
836
showcrop
showcrop
C
Ford 3000 fuel tank too low?
Replies
4
Views
849
Hobo,NC
Hobo,NC
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top