Hey guys-I have a mid 60s Massey with a z134 continental and a marvel schebler carb. Its a couple hours away from home. I want to. Replace the inline filter that goes in the elbow from the fuel line to the carb. Called a parts place and he said it may take the same one the ford 8N does, which I can pick up tomorrow. Anyone know if these parts are interchangeable?
- Thread starter chuck t
- Start date
Dieseltech
Well-known Member
- Location
- Akron, Indiana
The steel inlet line connects to a brass elbow, and there's USUALLY a screen on the elbow inside the carb. No filter was used in production, but could have been
added later.
added later.
Steve@Advance
Well-known Member
The Massey would have used a 5/16 flare fitting, I think the Ford did also.
But unless the screen is damaged or missing it can be cleaned and reused.
There was never an inline filter from the factory, only the screen in the elbow
and above the sediment bowl.
But unless the screen is damaged or missing it can be cleaned and reused.
There was never an inline filter from the factory, only the screen in the elbow
and above the sediment bowl.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy