Kubota zg23 zero turn lift cylinder

rrman61 · May 2, 2022

My deck lift cylinder is leaking on my zero turn mower.does anyone know if theres a seal kit for this cylinder or do I have to replace it and if so is there a source for reasonably priced kubota parts?

Steve@Advance · May 2, 2022

If the cylinder will come apart, good chance you can get the seals at a seal supply.

Take it apart, inspect everything for wear or damage. Then match up the seals.

If there is not a seal supply near by, you can mail in the seals, they match them and send the new ones. I use H&D in Dallas.

jm. · May 3, 2022

your cylinder # K3111-44950 is not serviced separately around $ 315.00 new and I have never been able to take one apart without destroying it. Good luck trying.

jm. · May 3, 2022

I might add most of the time the leak is at the inlet fitting check it real close and make sure it is actually the cylinder leaking.

rrman61 · May 3, 2022

So next option..aftermarket cylinder?any suggestions where I could find one?

Blackhole49 · May 3, 2022

Good luck finding an after market cylinder. The angle cylinder for my snow plow is over $600 and I haven't been able to find anything close. I would just buy the Kubota part.

jm. · May 3, 2022

I have a used one in Tennessee $ 200.00 E-mail is open

Kubota zg23 zero turn lift cylinder

rrman61

Well-known Member

Steve@Advance

Well-known Member

jm.

Well-known Member

jm.

Well-known Member

rrman61

Well-known Member

Blackhole49

Well-known Member

jm.

Well-known Member

Similar threads