(800) 853-2651
SHOP NOW

Super A Snow Plow Extension Arm

M

MSFARMALL

Member
I'm looking for the Touch Control extension arm for the Farmall Super A if anyone has a good source that won't cost an arm and a leg.
Thanks in advance.
 
Sorry for the poor description. This piece is attached to the right side touch control arm and is made out of approximately 2 flat bar that is curved downward to extend the reach of the lift arm. It has two holes that match the two pin holes of the touch control lift arm and an additional hole at each end of the extension arm.
 
Oh, so their would be one on each side then. I have a C with a blade. I could measure that part for you to copy but I think a C would be different than a Super A. Many guys use a piece of steel cable with a loop or an eye at each end in place of that piece. That works ok and allows the blade to float but you can't put pressure down on the blade. I have seen some of those arms with springs attached to cushion the blade. If your arms are missing I suspect you'll have to make new ones so I hope someone with a Super A will post here.
Dave.
 
I attached a picture. The piece I need is the curved flat bar.
cvphoto123293.jpg
 
If you know the distance between the holes the dog leg bend probably isn't critical. You could cut it from a flat plate or weld three pieces of, I'm guessing, 3/8 x 2
flat bar to get the bend.
 
Ive found one online for 100$ but thats a little too expensive for me. I think I will just end up making one. I have printed the picture and can enlarge it on printer until I get the correct size.
Thanks for the help!
 
You must log in or register to reply here.

Similar threads

crsutton81
McCormick Model M grain drill
Replies
2
Views
199
crsutton81
crsutton81
F
Farmall super c rockerarm
Replies
5
Views
238
560Dennis
560Dennis
S
PLEASE HELP ME FIND
Replies
17
Views
1K
HFJ
H
T
How to remove grain tank extension on combine?
Replies
17
Views
1K
504
5
J
Looking for a V-Belt
Replies
8
Views
538
Russ from MN
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top