I have a 2020 New Holland with only 300 hours and if I have only empty pallet forks on it will settle probably 1 foot at lift and tilt cylinders overnight. If I have a heavy load on bucket, I can hop off, whether engine running or not, and hear the bucket creek every few minutes while it's sitting there. Dealer says cylinders are not leaking, it leaks through the control valve but dealer says that's within spec.
- Thread starter jbar
- Start date
Bruce from Can.
Well-known Member
- Location
- Woodville, Ontario, Canada
Truthfully, the operator isnt supposed to leave the seat with the loader on the skid steer in a raised position.
Fritz Maurer
Well-known Member
One way to see if its in spec is try the same test on a similar sized Kubota. Then when your dealer tries to chisel you on the trade because the cylinders drift too fast, you can say well your service department says theyre in spec (this only works if your dealer sells Kubota)
Bruce from Can.
Well-known Member
- Location
- Woodville, Ontario, Canada
My skid just has a cage not a cab, so no door. I dont like the idea of my hand or foot slipping, and dropping the boom on me , if I was trying to get out under the raised boom.
BarnyardEngineering
Well-known Member
- Location
- Rochester, NY
I would not accept that answer if you're under 2 years or 2000 hours, because it's still in warranty and they're trying to push you off until it isn't.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy