ford1956tractor
Member
Have great 7810S that cant break adjustable front axle loose to move out. Tried hydraulic jack and minimal heat???
- Thread starter ford1956tractor
- Start date
BarnyardEngineering
Well-known Member
- Location
- Rochester, NY
"Tried hydraulic jack and minimal heat." That's limp-wristing it. Seriously, like you're not even trying...
You need serious heat and maybe even two hydraulic jacks, depending on how bad it is.
Don't even waste your time spraying panther pee on it. You may as well use your own pee for all the good it will do.
It might loosen up if you remove the clamp, drop a slightly undersize pin through the alignment hole, and drive it around. That is if it's a round axle. Square, not so much.
You need serious heat and maybe even two hydraulic jacks, depending on how bad it is.
Don't even waste your time spraying panther pee on it. You may as well use your own pee for all the good it will do.
It might loosen up if you remove the clamp, drop a slightly undersize pin through the alignment hole, and drive it around. That is if it's a round axle. Square, not so much.
ford1956tractor
Member
Thx for replies
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy