(800) 853-2651
SHOP NOW

1977 Case 450 Dozer

H

Harddollarranch

New User
I have a case dozer 1977 model cant find any timing mark on flywheel to be sure of TDC for the replacement of my injector pump after having it rebuilt any suggestion besides thaking the head off to be 100% sure any advice will be helpfull Thanks Much
 
You didn't time it BEFORE you pulled the pump??The marks may be on the front pulley. Or if it's like a friends ford. There are noo marks. You pull #1 injector
and use a dial indicator.Pull the valve cover and watch the valves at #1 cylinder.That will get you pretty close.
 
You should have a book. It would give step by step instructions on timing. Plus the degrees it should be timed at.And any other important informtion.If you had a book,and read it,you would not be in the predicament you are in now. Good luck.
 
Turn the pump inside drive slot so the dot aligns with the shaft end dot, that will get you close. Then install pump and turn engine by hand until the two pump marks align under the two
screw side cover. Look on the valve cover, some Case engines had the valve and timing spec on a cover decal. If I recall, NONE were set at TDC, more like 6 degrees BTDC..
 
You must log in or register to reply here.

Similar threads

M
4010 JD bogging after rebuilt Injector pump installed
Replies
10
Views
590
LarrySTN
L
D
268 injection timing help...
Replies
5
Views
163
damn1981
D
J
Case 310G dozer hydraulic problems
2 3
Replies
49
Views
3K
Jonathan Thomas
J
C
John Deere generator
Replies
12
Views
476
CLM66
C
J
Help with a non working Case Grain Drill
Replies
10
Views
494
300guy
3
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top