(800) 853-2651
SHOP NOW

Moline clutch

R

Ron Muhlenkamp

Member
I have a Moline Jetstar 3 Super
The clutch does not disengage
I shortened the linkage to the limit and it still does not disengage
What are likely causes
Thx Ron
 
I'm surprized that nobody responded to your post down on the MM forum.

In addition to what Shaun said, if the live pto shaft and the clutch shaft are seized together for some reason, it would behave like a stuck clutch because the live pto shaft goes through the center of the clutch shaft and it is splined into an adapter on the flywheel and turns all the time the engine is running.
 
I thought it was the throw out bearing
I split the tractor
The PTO shaft turns freely within the transmission shaft
The clutch package appears good
The clutch mechanism seems to work as it should
The throw out bearing seems good
Im running out of ideas
 
Is it possible someone put the clutch disk in backwards? I don't remember if it is even possible in that tractor but I have seen it happen in others.
 
IF you took the clutch apart and the friction surfaces were separated and clean/dry, it should operate. Make sure the over center linkage is not so loose that it fails to unlatch. (not sure which model you are discussing) Jim
 
I thought it was the throw out bearing
I split the tractor
The PTO shaft turns freely within the transmission shaft
The clutch package appears good
The clutch mechanism seems to work as it should
The throw out bearing seems good
Im running out of ideas
 
(quoted from post at 07:17:06 04/06/21) I thought it was the throw out bearing
I split the tractor
The PTO shaft turns freely within the transmission shaft
The clutch package appears good
The clutch mechanism seems to work as it should
The throw out bearing seems good
Im running out of ideas
Click to expand...


Why bother?
 
You must log in or register to reply here.

Similar threads

U
MF 35 Clutch Problem
Replies
8
Views
262
Uncle Fred 02
U
H
  • Question
Minneapolis Moline LO-100 Manure Spreader
Replies
2
Views
146
rrlund
R
D
Hart Parr 19-36 hard to put in gear
Replies
7
Views
268
scootergmc
S
D
John Deere 301A clutch
Replies
2
Views
249
Jim.ME
J
chube11
8n starts when keys off and buttons not pushed
Replies
4
Views
547
sotxbill
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top