(800) 853-2651
SHOP NOW

What brand light is this, Hobbs?? Need a rubber bezel.

R

RTR

Well-known Member
We have a Dynahoe 190-4 backhoe made by Bucyrus-Erie back in the 60s/70s and the rear work lights are about to fall apart. The original rubber bezels need replacement. The lights and bezels look like the rear light found on a Farmall 140 but not sure if its the same. I believe Hobbs made the light on the 140. I need to find a couple rubbers.
mvphoto71680.jpg


mvphoto71681.jpg


mvphoto71682.jpg
 
Try Grote Products, part number 91740 for a semi trailer tail light might work. Otherwise you might have to replace the entire light assembly.
 
It was years ago- when I rewired my 4020, I was impressed with how many pieces and parts JD provided for the various lamps they used. Now, I go with LED.
 
Not a new policy, seems like Steiner, Bates and Messicks are the ones it normally gets. The YT parts search and layout sure does not equal Steiners. I am convinced if the would spend a little time working on that they could sell more parts. I suspect they can get nearly everything Steiner can but probably focus on high traffic items. Just an outsiders opinion. I dont blame them for blocking competitors I know I would if I ran their show.
 
(quoted from post at 17:43:39 03/18/21) We have a Dynahoe 190-4 backhoe made by Bucyrus-Erie back in the 60s/70s and the rear work lights are about to fall apart. The original rubber bezels need replacement. The lights and bezels look like the rear light found on a Farmall 140 but not sure if its the same. I believe Hobbs made the light on the 140. I need to find a couple rubbers.
mvphoto71680.jpg


mvphoto71681.jpg


mvphoto71682.jpg
Click to expand...
+

I think I found the right bezel. It looks like it is a Hobbs light and I ordered (2) bezels from S teiner tractor and we shall see how they fit. Just wanted to let everyone know!
 
I priced rubber bezels for some regular lights like that and cost as much as a new light so will probably will use the ones that are good till they are shot then change the rest of them over to LED's. I've been putting those light bars on the front. Holy smoke you can see the other end of the field with them in a half mile field.
 
You must log in or register to reply here.

Similar threads

A
Optional "Red" Tail Light for ZT Series
Replies
18
Views
2K
molinegb
M
N
I need a tinfoil hat.....what about you?
2
Replies
29
Views
3K
wilamayb
W
W
What was I thinking? (or: Dealers can spot a sucker)
Replies
7
Views
2K
Phil Tibbetts
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top