4230 rockshaft piston cover.

msondeno · Nov 15, 2020

Just a quick question, when removing a rockshaft piston cover on a 4230 what will fall out? I have a slight leak to the outside and guessing it is the o-rings that have gotten hardened over time. I just don't want parts falling out that either won't go back in or I can't figure out where they go. I don't see anything in the parts manuals or service manuals that really shows anything. Experience is always the best anyway. Any help would be appreciated. Thanks in advance.

matthies · Nov 15, 2020

Just make sure you have the three point down. Or you will have one heck of a mess.

msondeno · Nov 15, 2020

I'm sure you would get a lap full of oil, but will anything else fall out and is it just the o-rings that will be in the cover? Thanks.

Tx Jim · Nov 16, 2020

With 3 pt lowered after removing RS cover one can access RS piston to R&R piston seal.

msondeno · Nov 16, 2020

I don't have to R&R the piston, just have a seep down the back of the tractor. The 3 point works fine.

Tx Jim · Nov 16, 2020

If 3 pt stays up then change only cover seals. You'll need part #s R65334 & 2741R

msondeno · Nov 16, 2020

That was my plan. Just didn't want to open a can of worms and thought I'd ask before I had more parts in my lap than I expected. Thank you for your info it is appreciated.

Tx Jim · Nov 16, 2020

I don't understand why the "F" vanished in my previous post F2741R

msondeno · Nov 16, 2020

Who would know. I already had the part numbers it was the procedure I was wondering about. I couldn't see any potential problems but, you never do. Thnx again.

4230 rockshaft piston cover.

msondeno

Member

matthies

Well-known Member

msondeno

Member

Tx Jim

Well-known Member

msondeno

Member

Tx Jim

Well-known Member

msondeno

Member

Tx Jim

Well-known Member

msondeno

Member

Similar threads