A few projects

SVcummins · Oct 24, 2020

Got one plow put away and got the wheel reinforcement rings on the 4020 and welded in place

David G · Oct 24, 2020

I think putting those rings on 4020 is good idea, those rims are a weak place.

Do keep an eye on the studs, buddy did that and had hard time keeping them tight.

How are hydraulics looking?

SVcummins · Oct 24, 2020

Beginning to think my loader packings are shot again which makes me happy since they are only about 20 hours old

David G · Oct 24, 2020

Happy?

JayinNY · Oct 24, 2020

Ill have to get some of that till guard, lot easier than wiping grease on my plows.

SVcummins · Oct 24, 2020

Never broke a factory wheel before

SVcummins · Oct 24, 2020

It lasts wiay better than grease too . I put it on at 13 degrees last time it was still on there two years latter when i hooked on this fall.

SVcummins · Oct 24, 2020

This one has been studded since 2007 need to order a new hub probably this winter

Case Nutty 1660 · Oct 25, 2020

to wear out that fast can mean a few things burred/rusted cylinder tubes,bent rod, sharp edge/damaging the seals on install also causes that

GordoSD · Oct 25, 2020

I doubt if that wheel will stay on. Only about 50% of the nut is holding on.

A few projects

SVcummins

Well-known Member

David G

Well-known Member

SVcummins

Well-known Member

David G

Well-known Member

JayinNY

Well-known Member

SVcummins

Well-known Member

SVcummins

Well-known Member

SVcummins

Well-known Member

Case Nutty 1660

Well-known Member

GordoSD

Well-known Member

Similar threads