olgentdc
Well-known Member
I am not good at brazing , There is a 1/2 inch steel line leaking on newly purchased my NH 855, i think it froze and burst from water condensation . is there such thing as a bolt on wrap around clamp?
- Thread starter olgentdc
- Start date
Janicholson
Well-known Member
Probably could find one, but I would not recommend it. Take the line off, and have it repaired, or get a used line. A section could be cut out, and hose fittings brazed on for a hydraulic hose to replace that segment. Safer and more confident in the reliability. Jim
shaun wallace
Well-known Member
New Holland has in service parts a 3ft section of 3/8 steel tubing and swedge lok fitting to replace bad sections of line.
OP
OP
olgentdc
Well-known Member
that is what i need ,.. i will check with my local dealer ,, thank you
the tractor vet
Well-known Member
When i come up against a problem like this and a BRAZE job is not the answer though i have brazed a few in my time in a bind that have worked well , i set about making a new line . I am fortunate enough that just 26 miles up the road i have a Parker Dist. and i can buy any size hyd line i want in 20 ft. lengths . Yes i layed out the bucks for the Parker hand tubing benders and use them often even on doing brake lines . I get a lenght of line that i need and have them cut the 20 footer down to the length i need for east of transport and the corasponding (sp) and play build a line . What ya need to know is Wall thickness and I D. of the line in question a little studding on how to do the bends and the bender for the line , yes they are pricey per bender i have them from 1/8 up to 5/8ths and guard them with my life. In other words if you want to bend a line and use my benders there is a charge and i am include ME . I have used the hyd, SPICE repairs also and they work as designed when you follow directions. I have brazed hyd Pipe couplings on lines and replaced bad sections with hyd hose of the sme inside dia. as the line .
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy