Davis loader

anallisguy · Jun 22, 2020

I've got a Davis 102E loader on an International 300U. I believe I can add hydraulic fluid thru the vent on top, but I haven't noticed where to check the hydraulic fluid on this unit. I'm sure someone out there knows. Thanks

wore out · Jun 22, 2020

Typically, the Davis loaders have a small (1/8") pipe plug in the loader frame/tank a few inches down from where the fill port is.

You remove the plug and add oil 'til oil starts to come out of the test port.

MKinON · Jun 22, 2020

On the newer models on our MFs, the level is indicated by a dipstick hanging from the vent cap. I think it’s about 17” below the vent/filler base. Seems it’s might be about where that small dia hose comes out the back of your tank.

anallisguy · Jun 23, 2020

The only plug is the one at the bottom that you can see in the picture.
I'm thinking maybe unhook that small hose, fill from the top until it reaches
that level, but I'm open to suggestions. Thanks

wore out · Jun 23, 2020

That sounds like a good plan to me.

Davis loader

anallisguy

Member

wore out

Well-known Member

MKinON

Member

anallisguy

Member

wore out

Well-known Member

Similar threads