(800) 853-2651
SHOP NOW

1965 ford 4500 3cly gas

V

Venton

New User
Looking for a wiring diagram for the wires from the fuel sending unit to the dash board only have 1 wire hooked up now I believe its the ground the hot wire is loose & there is no open post to connect it to??
 
There should only be 2 wires for the gauge to function.

A hot from the ignition, and a single wire to the sending unit.

If there is only one stud on back of the gauge, the other must be broken off.

The tank and sending unit case must be grounded. Usually the sending unit grounds through contact with the tank, either way the sending unit provides the variable ground to make the gauge move to the proper position.

If there are other wires or connections on the gauge, they are for the light (if equipped).
Gauge Wiring
 
(quoted from post at 12:37:52 06/04/20) Looking for a wiring diagram for the wires from the fuel sending unit to the dash board only have 1 wire hooked up now I believe its the ground the hot wire is loose & there is no open post to connect it to??
Click to expand...


Thanks for the info took a look at the back of the dash saw no broken post took a picture of it maybe it would help seeing what Im looking at also no part# just made in England
 
(quoted from post at 14:29:33 06/05/20)
(quoted from post at 12:37:52 06/04/20) Looking for a wiring diagram for the wires from the fuel sending unit to the dash board only have 1 wire hooked up now I believe its the ground the hot wire is loose & there is no open post to connect it to??
Click to expand...
here is your picture?


Thanks for the info took a look at the back of the dash saw no broken post took a picture of it maybe it would help seeing what Im looking at also no part# just made in England
Click to expand...
 
(quoted from post at 12:37:52 06/04/20) Looking for a wiring diagram for the wires from the fuel sending unit to the dash board only have 1 wire hooked up now I believe its the ground the hot wire is loose & there is no open post to connect it to??
Click to expand...
 
(reply to post at 12:37:52 06/04/20)
Click to expand...
ploaded pic dont know if it went thru I saw no broken post just a single post behind fuel gauge & a hot wire from the Ignition switch to that post, dont know if dash cluster is original I have found no part #s just that it was made in England if pic didnt go thru Ill try again thanks
 
You must log in or register to reply here.

Similar threads

N
1969 Ford 4500 alternator wiring
Replies
6
Views
772
Nerolord
N
D
Trying to understand cab/lights wiring connection to light switch on farmall 826 diesel
Replies
2
Views
234
used red MN
U
G
1980 Ford 445 diesel tractor new alternator output only 12.28
Replies
5
Views
324
Texasmark
T
D
3 wire altenator indicator light or diode? Ammeter guage?
2
Replies
23
Views
1K
DN-N-TN
D
J
Ford 3910 Electrical issue
Replies
9
Views
382
Tim PloughNman Daley RIP
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top