Discbine blades

rick n ohio · May 13, 2020

Anyone ever try sharpening discbine cutting blades with a angle grinder or just replace with new oned

4520BW · May 13, 2020

I always just replace them. Usually a new set to start the year then flip them in the summer

flying belgian · May 13, 2020

Yes, I always sharpen mine.

M Nut · May 13, 2020

I?ll sharpen mine a time or two before replacing.

dcarp · May 13, 2020

Easily done with angle grinder. I have done that when really pressed for time. Usually I flip them and when both sides are dull replace them. Personal preference is in play here. The manufacturer will tell you not to sharpen because it causes an out of balance situation increasing wear on the bearings. But, as always, they have a financial interest in you buying new blades.

rick n ohio · May 13, 2020

Thanks for the replys I appreciate it fellas

Alvin 41 · May 13, 2020

Seems like I have to bend them up or down often and usually sharpen as well.

showcrop · May 14, 2020

I probably did a little at first but then just replaced them. They don't cost that much. I put new ones on in between first and second cut.

Discbine blades

rick n ohio

Member

4520BW

Well-known Member

flying belgian

Well-known Member

M Nut

Well-known Member

dcarp

Well-known Member

rick n ohio

Member

Alvin 41

Member

showcrop

Well-known Member

Similar threads