(800) 853-2651
SHOP NOW

Pto shaft lubrication update

3

300jk

Well-known Member
After cleaning the inner shaft and wire wheeling it I ended up using corn
head grease on it. Works good now. There is no fitting, and I don't think
the outer shaft wall is thick enough to put one in it. It was pretty
neglected by the previous owner. Thanks for everyones responses.
 
When I bought our 3 pt. auger the drive shaft had been neglected that way, but worse. I hooked it up between 2 trees with a come-a-long, put about 1,000 pounds of tension on it, started heating and tapping. Pretty soon it popped apart, I cleaned it up and it's been fine ever since.
 
it has been my experience that whatever I use, I need to plan to pull it apart, clean it up good, and re lube occasionally.
 
I have a 4 spinner rotary hay tedder with one of those triangle foreign pto shafts. I have to oil it good every time I use it and pull it completely apart before winter storage if I want to get it a part without a fight the next spring. Tom
 
You must log in or register to reply here.

Similar threads

D
Lube fitting in PTO shaft
Replies
12
Views
753
Fritz Maurer
F
C
JD 40W PTO shaft lubrication question
Replies
3
Views
539
M-MAN
M-MAN
M
Ford 860 rear pto housing welded to axle?
Replies
10
Views
743
ErnieD
E
M
Ford 3000 PTO shaft seal
Replies
11
Views
729
mx842
M
L
Oliver 550 PTO
Replies
10
Views
1K
SPMN
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top