JD Lower cast iron bearing holder on a 4 gang Drag Disk

Kevin Happke · May 4, 2020

I am looking for the lower half of the bearing holder that I believe that was made out of cast iron,
that holds bearing spool on the disk.....The is a 4 Gang John Deere Disk....I am in MN....Message
here or call 320-468-6474.....Thanks, Kevin

caterpillar guy · May 5, 2020

Pictures would help a lot. Sounds like the old cast bearing and I think I heard those were no longer available through deere would have to find an old used disc for that. Though I thought those only had 2 1/2 or 5/8 th's bolts to hold them together.

Tx Jim · May 5, 2020

I agree with Cat Guy in that a picture would help ID disk harrow. Your implements model could be JB or JBA.

tomstractorsandtoys · May 5, 2020

It could also be a KBA. On the KBA there were two size spools. I most likely have some of the larger ones if I can find them. Post a pic or do a Google image search or Deere parts catalog search to help figure out what you have. Tom

Tx Jim · May 5, 2020

Tom
I disagree that Kevin's disk harrow could be a model KBA. KBA had white iron brg halves side by side not one 1/2 on top of other 1/2.

Tx Jim · May 5, 2020

JA & JBA disk shaft parts schematic shown below

Kevin Happke · May 5, 2020

Hello Jim, Do you have the part nos. for the top half and the bottom half? Any ideals on where to
find a bottom half?

Thanks, Kevin

Tx Jim · May 6, 2020

JD parts is available online for free. Parts description shows there's a year built break on part # @ year 1950. IIRC the part # should be cast into the old part.

JD Lower cast iron bearing holder on a 4 gang Drag Disk

Kevin Happke

Member

caterpillar guy

Well-known Member

Tx Jim

Well-known Member

tomstractorsandtoys

Well-known Member

Tx Jim

Well-known Member

Tx Jim

Well-known Member

Kevin Happke

Member

Tx Jim

Well-known Member

Similar threads