Courtland1949
Member
What is the best easy/route to run a wire from under the dash through the firewall to the coil in a 1965 Chevelle ? It's not looking obvious like on my C10...this is a knee knocker tach.
Thxx...
Thxx...
- Thread starter Courtland1949
- Start date
Janicholson
Well-known Member
Punch a hole through the rubber grommet where the big bundle goes through with an ice pic. push the wire through from the engine side with silicone lube on it. 1000 times easier than the other way. Jim
Bob Harvey
Well-known Member
Good pic. When I had my farm I was given a nanny and a kid. Didn't know enough to say no. A pal stopped on his way to pick up his sister in Calgary in his dad's pristine Volvo. The minute he stopped, the kid jumped up on the hood and slid around a little. We got the little sucker off and looked for scratches and such - none. Dad loved that car and probably had 10 coats of wax on it ! P.S. a few days later I got rid if the goats to another hippie sucker !
Courtland1949
Member
I think I can sneak it through the grommet... I'll give it a shot...
Courtland1949
Member
Cool 64. Have you had it long...?
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy