Chain saw fuel line?

Tractorcedric · Mar 18, 2020

Anyone got a good way to get that fuel line into the tank?

old · Mar 18, 2020

Cut the end of the line off at an angle so you can then put the tip of the angle into the tank and grab it to pull it in with needle nose pliers

BarnyardEngineering · Mar 18, 2020

What old said. Works for me every time.

Russ from MN · Mar 18, 2020

I've done it kind of like old, but I had to hook a wire onto it to pull it through. So I cut them at a long angle, poke a hole near the end to hook the wire in, then grease the fuel line. Then thread the wire in the tank and out the filler hole, and pull the line in, then cut it off square and put the filter on the end. You just need to buy a little longer tube than what you need.

Mike(NEOhio) · Mar 18, 2020

Cut it at an angle as was said and put a little oil on it.

Tractorcedric · Mar 18, 2020

Thanks for the knowledge! There is so much on this site!

AzPeapicker · Mar 19, 2020

I took a piece of old throttle cable from a control cable cut off more than needed , using 1 wire from the cable , ran it down thru the hole in the tank and out the filler hole after cutting the hose at an angle put the wire thru the hose and pulled thru the tank . once thru the tank pulled all that was needed cut off excess .

Axpeapicker

Chain saw fuel line?

Tractorcedric

Member

old

Well-known Member

BarnyardEngineering

Well-known Member

Russ from MN

Well-known Member

Mike(NEOhio)

Well-known Member

Tractorcedric

Member

AzPeapicker

Member

Similar threads