(800) 853-2651
SHOP NOW

Ford 641 Transmission is not turning

S

spencerguitar3120

New User
I had a gear on my 641 brake inside the transmission.So I split the tractor and took the top gear cluster and installed the new gear to replace the bad one. Now when i put it in the transmission is hanging up. should I be able to turn the output shaft after it is installed? Or what could be the cause i reinstalled as i pulled everything out.


Thanks
Spencer
 
If the wheels are off the ground, it should turn the output shaft. If the tractor is still apart, and lid off, finding the issue will be easier. A tooth or bearing part might be stuck in between the teeth of a different gear. Jim
 
(quoted from post at 08:24:41 10/18/19) If the wheels are off the ground, it should turn the output shaft. If the tractor is still apart, and lid off, finding the issue will be easier. A tooth or bearing part might be stuck in between the teeth of a different gear. Jim
Click to expand...



The tractor is still apart nothing seems to be crossed. should you be able to turn the out put shaft with a pipe wrench?
 
It should be easy to turn, no pipe wrench needed.

If the top is not back on, it may be locked in 2 gears. Be sure the shift gate is lined up, that should give neutral. You should be able to slide one fork at a time and put it through each gear.

But if it locks, and is not in 2 gears, something is wrong. Much easier to find it now than later. Putting it under power can result in serious and expensive damage.
 
You must log in or register to reply here.

Similar threads

F
641 sherman transmission
Replies
8
Views
892
michford
michford
M
Super M transmission shaft seal
Replies
7
Views
220
Mark Poss
M
G
Ford 861 input shaft seals
Replies
6
Views
396
used red MN
U
T
How to seal transmission bearing carriers
Replies
3
Views
256
T.R.K.
T
G
help with ring gear ford 8n
Replies
5
Views
252
Gary Singleton
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top