(800) 853-2651
SHOP NOW

TE20 with Continental Motor

G

GregoryZubal

New User
Ben trying to figure this out. I have a TE20 (should be) with SN 79687. That would make it a 1949. However the motor is stamped Z120A600 making it the American motor. Is this a replacement based on the fact the Z120's were supposed to be done at SN 45000-48000 or did they really have a bunch of these left over?

I need to replace the input shaft seaL (at least I believe thats the issue) and want to make sure i know everything i need to know.
 
As per Parts Book........TE 20....TO 20...TO 30...TEA-20....all have the same parts as per IN PUT SHAFT:
#'s 43-44-45-46-47

# 46 OIL SEAL...Part # 195 760 M1

Ferguson started out (Coventry England) with a Continental Engine.....then changed to a "Standard Engine" (Coventry England)

Ferguson Tractors assembled in the USA.....Continental Engines....

I have no idea if the above Part # is still a good number...

Bob....
cvphoto38057.jpg


cvphoto38058.jpg


cvphoto38059.jpg
 
You must log in or register to reply here.

Similar threads

D
TE20 vs TO20 Ferguson
Replies
2
Views
254
DRussell
D
3
Continental 4 flat head engine
Replies
14
Views
2K
37 chief
3
W
Ferguson TE20 - converted to 12V with a generator?
Replies
9
Views
950
Jim.ME
J
P
Bearings for Continental H277, H260
Replies
12
Views
733
54robbie
5
W
D17 Engine Oil Filter Pressure
Replies
7
Views
595
Allis Dave
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top