(800) 853-2651
SHOP NOW

Carraro axle help please

S

skybarnum

New User
I have a Ford 7710 with a carraro 709-19S2 front axle. Right side hub is leaking. I have already purchased seals from the local stealership. But I cannot get the damn hub apart. Someone has been into it befor me and the sealant they used is hard and grey, frankly it looks like JB weld...

Wheel has been removed, the 2 large countersink screws have been removed. Outer carrier will not come off. It appears it is solidly connected at 2 opposing wheel studs. What am I missing. Or is it rusted on/glued on.
 
I went and had a beer, some lunch and thought a bit.
I put some heat to it and hit it with a bigger hammer. Hub is apart now.

Not sure what they used as a sealant but I've had seized pistons come out easier than this thing came apart.
 
Been a few times had to quit and rethink the situation. Get a
clear mind and get back after it. A cold beer and a look at the
manual has helped. Advise has always helped but that beer
sure hit the spot.
 
Worked on a lot of Carraro axles, 2 of the wheel studs have a shoulder on them and
have to be removed before the hub can come off. MJ.
 
You must log in or register to reply here.

Similar threads

crsutton81
F 600 rear axle update
Replies
7
Views
582
crsutton81
crsutton81
J
7710 Ford with apl325 front axle
Replies
2
Views
719
Bruce from Can.
Bruce from Can.
J
Ford 7710 4wd with zf apl325 axle
Replies
2
Views
2K
jmh54
J
Z
New rear hubs won't tighten to new axle
Replies
4
Views
2K
cgun
C
R
1940 9N axle removed
Replies
2
Views
937
racerjim0
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top