(800) 853-2651
SHOP NOW

C50 grain truck water pump

D

Dave H (MI)

Well-known Member
Finally getting around to getting this fixed. Today I removed the fan, double pully behind the fan, belts, hoses. Looks like it mounts on studs? I ask because I have never touched one of these before. There is what appears to be a stud with a nut on it on the left and the one pictured on the right which has the alternator bracket and some other (I dunno what it is) stuff. I am assuming there are more studs underneath but have not been able to get down there yet. Am I at the point where I unbolt the water pump and take it off??? Any advice appreciated. I would prefer not to screw anything up too badly. :)

cvphoto32766.jpg
 
There are only 4 bolts holding it on, remove the nuts you see, and the brackets, then the studs, and its off, clean the gasket areas and replace.
 
That's not a stud, but a bolt with a studded head.

Just remove the brackets, then the bolt comes out.

Isn't this the engine you're not sure of the year or size?

Be sure to take the pump with you to match up the pulley flange height and hose connections.

Since the bolts go through into the water jacket, some sealer on the threads is a good idea.
 
You must log in or register to reply here.

Similar threads

RedMF40
Replace fan clutch with water pump?
Replies
18
Views
558
timcasbolt
timcasbolt
M
Water pump leaking
Replies
15
Views
566
Gary Mitchell
Gary Mitchell
C
MF 65 water pump pulley slipping on shaft
Replies
1
Views
221
Jim.ME
J
H
2030 water pump
Replies
10
Views
384
buickanddeere
B
Btzj02
960 Power Steering Pump bracket Spacers
Replies
6
Views
416
showcrop
showcrop
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top