Had a good laugh at this!

TimWafer · Apr 20, 2019

Ive been working on a Gleaner K2 I recently bought. Im trying to get the individual wheel brakes working. I was doing research on the master cylinder on the net and found a post , where some guy was working on the same part # master cylinder out of an old towmotor forklift. It got me to thinking about the old forklift I had and working on the brakes on that a number of years ago. After reading through the posts on this subject I realized they were my own posts from about 10 years ago!! I thought that master cylinder had a familiar look about it. Duh!
Getting old is taking its toll!

johnofnewhaven · Apr 20, 2019

It's ok. At least you did not
contact the guy and have a
conversation with him.

paul · Apr 20, 2019

That is funny.

I can eee myself..........

Paul

Eric in IL · Apr 20, 2019

That's the trouble with the internet, trying to figure out if the guy with the tow motor was giving correct info or blowing smoke.

Rich'sToys · Apr 20, 2019

(quoted from post at 09:12:04 04/20/19) It's ok. At least you did not
contact the guy and have a
conversation with him.

I'll bet he talks to him every day!!

pete 23 · Apr 20, 2019

Many years ago, I read an article in a magazine about testing for leakage between cylinders in a two stroke snowmobile engine. I questioned the result as some engines did not have a positive seal between cylinder. They had a close tolerance labyrinth seal I think they called it. Just a grooved section.

Anyway, I wrote the author a letter and sometime later, my brother said he saw an answer to a question in the new issues of the magazine about the same subject I was referencing. I read the answer and my brother had neglected to read who asked the question, it was non other than me.

Had a good laugh at this!

TimWafer

Member

johnofnewhaven

Well-known Member

paul

Well-known Member

Eric in IL

Well-known Member

Rich'sToys

Well-known Member

pete 23

Well-known Member

Similar threads