mikewood869
Well-known Member
On the tractor I was thinking is a Ford 6610 with rear wheel drive, 8spd with 4 reverse and dual remotes (1982 or 1983 model) and a ford 777B loader. Just out of curiosity would it be possible to run a brush cutter off the loaders hydraulics? If not, engine mount hydraulic pump (rear left side of the engine, there is a plate their), or off the crank (I think they had a kit to make the loader to run off a crank)? When the brush cutter is attached to the loader. Like this:
https://www.youtube.com/watch?v=j2adjkAfyvQ
I was thinking 7 ft, we have a woods 208 brush cutter (8 ft) and that is pushing the tractor without any weights (the rear of the tractor goes up into the air. I was hoping to cut up to 8 inches thick.
Sorry for the upside down photos.
https://www.youtube.com/watch?v=j2adjkAfyvQ
I was thinking 7 ft, we have a woods 208 brush cutter (8 ft) and that is pushing the tractor without any weights (the rear of the tractor goes up into the air. I was hoping to cut up to 8 inches thick.
Sorry for the upside down photos.