(800) 853-2651
SHOP NOW

Delta red

S

SVcummins

Well-known Member
Delta is the issue with my tractor photo in ?
cvphoto6736.png
 
Hey SV you have to subscribe! That's your Girl's magazine. And you should get the Oliver one too while your at it!!! Lol... Merry Christmas
 
SV,Most of us have too many tractor magazines. But hey,everything looks better with a cute blonde in the picture. LOL!
 
I don't get magazines -- ANY magazines. Every time I subscribe, I get more junk mail, more junk email, and more unwanted junk calls.

Some magazines are good about NOT letting out your info. With others, it's almost like you pay them not for the magazine, but you're paying them to distribute your contact info. Sales catalogs are the worst!
 
I would like to have an Oliver and sherry both she could operate a tractor for my custom farming business
 
I don?t get much unwanted mail except my parts bill
and the fuel bill and tractor payment reminders
 
You need a 2255 with a kitty cat! As for Sherry you will have to figure that part out.Lol I have talked with her on The phone and email she was very nice...
 
I?ve emailed her a bit and she?s very nice . I bet an Oliver With a cat would be nice . I like this one to
cvphoto6802.jpg
 
Oh ya. That has a Hercules which is good too. Sure would look good pulling a disc chisel. Do you chisel plow any if your ground out there?
 
A little bit my chisel springs are getting pretty weak it works good as a cultivator with 16 inch wheatland sweeps it will go pretty deep If you run 3 passes with it it?s a 16 foot John Deere 100 tool carrier I pull it in front of the drill does a good job bringing the moisture up so the seed will germinate in a hurry . Planning on ripping next year after I get the triticale off and then maybe chisel plow once or twice through the fall then depending on moisture I may plant again
cvphoto6803.jpg


cvphoto6804.jpg
 
You must log in or register to reply here.

Similar threads

D
  • Locked
Susan's Obituary
2
Replies
33
Views
2K
Richard G.
R
W
Delta Rockwell Parts
Replies
3
Views
360
DoubleO7
DoubleO7
G
Central Machinery Wood Lathe
Replies
13
Views
709
super99
super99
S
return spring for Delta 15091 Drill Press
Replies
6
Views
720
Mule Meat
Mule Meat
super99
Drill Press Return Spring
Replies
10
Views
825
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top