(800) 853-2651
SHOP NOW

Anadolu power steering adjustment

Joe Ferguson

Joe Ferguson

Member
On a 1966 Ford 2000 3 cyl diesel with Anadolu add-on power steering.
It is little hard to turn left. There is an Allen head bolt with locking nut
adjustment?) ont the actuator valve on the cylinder the bolt pass trough a slide
probably to avoid valve tipping. Is this bolt is an adjustment or only to avoid valve tipping.
If this bolt is an adjustment I will appreciate to have the adjut procedure.
I purchased this tractor few years ago previous owner did not have any instructions on
the Anadolu kit.

Thank you in advance

Bart CA
 
Hydraulic pressure is pounds per square inch, rod side of cylinder has less square inches for the pressure to work on therefore less push. You may have other problems, but it will not have the same power.
 

No that bolt keeps the spacer between the valve body and the control arm parallel and keeps the shift pin sliding forwards and backwards. can you turn the little bolt up and down in the window? If not the shift pin bolt is too tight and causing binding.
 
You must log in or register to reply here.

Similar threads

P
350 steering box reassembly
Replies
4
Views
459
Paul 300 U
P
D
Massey Ferguson 205 3 cyl perkins diesel power steering conversion
Replies
1
Views
244
Caryc
C
mikewood869
Ford 3400 power steering cylinder line seal
Replies
5
Views
346
Texasmark
T
L
Backlash adjustment without removing steering assembly?
Replies
3
Views
1K
Den N Ms
D
D
2010 Power steering
Replies
17
Views
734
Daniel in PA
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top