(800) 853-2651
SHOP NOW

856 1000 rpm pto shaft

P

Pork chop 1568

Member
My 1000 rpm pto shaft is bent, it came that way when I bought it from the auction. Does the whole housing need to be removed from the tractor or can it be replaced by removing the seal and some sort of snap ring ?
 
Since it's no good the way it is, might try straightening it in place. Did that on another tractor I had years ago, and saved it using a long heavy walled pipe.
 
The whole unit must be removed.It takes special tools(and the book) to disassemble.It can get expencive if you cant do it your self.If you don't need or use the 1000 shaft,leave it be.
 
Must come out and like Delt Red said ya need some special tooling . You need a clutch drum spring compressor a really good pair of heavy snap ring pliers and ya need the special fitting to set clutch loc up pressures . The unit is heavy and best removed by usen a Cherry picker and once you have the bolts out and on this there are two short bolts you leave in till you have everything inside taken apart . You will want to use a pieces of pipe over the 540 shaft as a lever so you can tip the back end down as you come back so you do not bang the pick up tube for the PTO hyd. pump as they are thin wall tubing and will bed / dent easily . I can be in and out of a pto and have the tractor back u and running in about four hours , Don't work as fast as i use to .
 
You must log in or register to reply here.

Similar threads

super99
1655 Dual Speed PTO
Replies
2
Views
277
NEWIoliver
N
P
856 pto driven gear removal
Replies
5
Views
279
Janicholson
Janicholson
B
Ford 2000 PTO Output Shaft removal
Replies
10
Views
403
Bennett French
B
D
JD 4010 540 pto to 1000 pto change
Replies
4
Views
474
Tx Jim
Tx Jim
O
Fox 2100 chopper
Replies
4
Views
352
NY 986
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top