Terminal block.

TexasCowboy · Apr 26, 2018

The threads on the terminal block post for the hot wires are stripped. The flat head screws that mount the terminal block are original. ie 65 years old. WD 40 on the head of the screw isn't going to help the threads. So has anybody found a good way to remove the terminal block to replace damaged posts? Or I could just drill the heads off and go at it that way?

SVcummins · Apr 26, 2018

What about an impact driver ? What?s the block on can you just replace the whole thing ? It?s probably corroded so bad you might not be able to clean it up anyway

old-9 · Apr 26, 2018

Is this what you are talking about?
Untitled URL Link

TJV · Apr 27, 2018

Is this what your looking for https://www.link_disallowed/Junction-BlockIHS2244
Untitled URL Link

TJV · Apr 27, 2018

Ill try again but since they disallowed it the first time Steiner has one it's part number IHS2244 that might be what your looking for ill try to include a picture

Terminal block.

TexasCowboy

Member

SVcummins

Well-known Member

old-9

Well-known Member

TJV

Member

TJV

Member

Similar threads