pto distance

Greenpully · Nov 22, 2017

Can someone tell me the distance between the end of pto shaft and hole in drawbar?This is 540 rpm tractor.Thank you GP

Scott 730 · Nov 22, 2017

rustyfarmall · Nov 23, 2017

(quoted from post at 19:16:16 11/22/17) 14"

That sounds correct.

oldsarge · Nov 23, 2017

Not sure,but I think I forgot

buickanddeere · Nov 23, 2017

http://standards.sae.org/j1170_199302/

rusty6 · Nov 23, 2017

I think the distance required varies on some machines. I only have two settings for drawbar length on my 2090 Case. I have to run it in the short position when using my NH round baler as the manual calls for a certain length (can't remember it now). If you have a manual for the pto powered machine I would think they specify dimensions in there.

Part Time Pete · Nov 23, 2017

That's funny Oldsarge..

Olliejunkie · Nov 23, 2017

(quoted from post at 08:43:11 11/23/17) I think the distance required varies on some machines. I only have two settings for drawbar length on my 2090 Case. I have to run it in the short position when using my NH round baler as the manual calls for a certain length (can't remember it now). If you have a manual for the pto powered machine I would think they specify dimensions in there.

Ditto. I think it verys. I would check with your equipment manual.

Tx Jim · Nov 23, 2017

(quoted from post at 12:50:35 11/23/17)
Ditto. I think it verys. I would check with your equipment manual.

No drawbar length doesn't vary as it is SAE standard. 540 rpm is 14'' from end of tractor pto shaft to center of hole in drawbar. 1000 rpm is 16''.

westga · Nov 23, 2017

Just so I know about what year did this 14 inches become standard?

pto distance

Greenpully

Member

Scott 730

Well-known Member

rustyfarmall

Well-known Member

oldsarge

Well-known Member

buickanddeere

Well-known Member

rusty6

Well-known Member

Part Time Pete

Well-known Member

Olliejunkie

Well-known Member

Tx Jim

Well-known Member

westga

Member

Similar threads