(800) 853-2651
SHOP NOW

IH 424 Hydraulics

A

aconrad

New User
I have a IH 424 gas (no loader, no PS) that I was able to get running after sitting for 2 years. Ill stop here and note that I am not a mechanic so this was a victory in itself. One problem that we noticed was there was approximately 2 gallons of fluid removed when we changed the oil. Next we noticed that there was almost no hydraulic fluid when we went to change it. One problem this tractor had up to the time it was parked two years ago was it would stop lifting any implements after it got to operating temp. Now if lifted it will hold the implement once up. I am having difficulty imagining how the Hydraulic fluid is getting mixed with the engine oil.

any help would be greatly appreciated.
 
Hi, I have never worked on the gas model only the Diesel version but I believe the hydraulic pump is on the right front of engine run by the timing gears. Most likely the front drive shaft seal on the hydraulic pump is leaking hydraulic oil into the crankcase. Seals can be replaced but if shaft is worn then shaft will require a sleeve and new seals. You could search the web for a replacement.
 
You must log in or register to reply here.

Similar threads

D
424 International Hydralic Lift
Replies
6
Views
167
M-MAN
M-MAN
W
424 IH needs new hydraulic pump
Replies
8
Views
315
wwoodrow
W
F
Ford Jubilee - oil/fluids
Replies
6
Views
264
Ford Jubilee
F
D
John Deere 301A clutch
Replies
2
Views
249
Jim.ME
J
J
Bleeding Hydraulics on a John Deere 2640
2
Replies
21
Views
948
JohnGough
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top