Newbie1986
New User
I just bought a 535 round baler and on my first roll my net wrap wouldn't feed. I recently got the net wrap to feed but now the rollers will not disengage. I've taken the switch off and cleaned it but it still will not disengage.
- Thread starter Newbie1986
- Start date
The JD 535 baler has a hydraulic system to run the mesh wrap system. You need to have all the springs and linkages on the right side working correctly to engage and dis-engage the hydraulic pump for it to work. This is on the baler right by the hydraulic pump not back on the mesh warp attachment. The system is hydraulic and mechanical so I do not know what "switch" you took off and cleaned but a switch will not do you any good on a JD 535.
I will NOT go into setting one in a post. You need to get a manual and check your baler out. The JD 535 baler is very reliable when set right. IF you do not have it set right or have broken springs/linkages it will drive you to drink.
I will NOT go into setting one in a post. You need to get a manual and check your baler out. The JD 535 baler is very reliable when set right. IF you do not have it set right or have broken springs/linkages it will drive you to drink.
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
Ditto what JD Seller stated [/url]
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
Ditto what JD Seller stated about checking that 5 springs are present on linkage by twine pump & in the fact switch has no control on 535 surface wrap attachment. Check operation of cylinders(key 1). Also be sure hyd spool valve is shifting when twine tube reaches RH side of baler when mechanism is tripped.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy