(800) 853-2651
SHOP NOW

IH 3200A Skidsteer.

F

Farmallboy66

Member
I Have A IH 3200A skidsteer it sat for about 9 years. it has A Two cylinder deutz Diesel in it. So the cylinders were full of water. and I Pulled the injectors and got it to spin over and get he water out.
Then I put it back together and tried starting it. and primed the hell out of it. nothing. can't get it to pop on starter fluid. so whats my next move? It has good compression. could there still be water in it? maybe in the fuel? I never changed the fuel. The oil has water it. Otherwise what cheap motor could I could I put in it? Any help would be great. Colin.
 
sounds like you have work to do yet. change oil, change fuel filters and fuel. get it primed.
and for the compression, did you actually check it with a guage? because if it had water in the cyl's the rings maybe stuck. and how long was this water in there? have you checked if its getting fuel to the injectors? sounds as if you did not even lube the cyl's , so i cant see it having compression to start.
 
It's a little late now, but the oil should have been changed before it was turned over! About any engine oil will work, as it will need to be changed a couple times to get the majority of the water out, if it does start.

Some oil in the cylinders will also help. Something light, rust penetrant, ATF, something to seep down and free the rings.

Have you loosened the injector lines and got fuel up to the injectors? If not, that will be necessary to purge air from the system. If it sat with the kill lever in the stop position, the pump may be stuck in the stop position. If it is, no fuel will come up to the injectors.

If water is in the fuel, it probably needs to be completely disassembled and every component cleaned. Diesel will grow algae and dry out to a sticky residue that clogs and sticks everything.

Once the fuel system is back up, watch for white exhaust vapor. That indicated the cylinders are getting fuel, a necessity for any hope of starting.
 
You must log in or register to reply here.

Similar threads

G
IH 3500A Fuel problems
Replies
8
Views
467
grounder
G
super99
What a Mess!!!
Replies
15
Views
2K
sonnythomas
S
T
4250 John Deere electrical problems
Replies
8
Views
302
wore out
wore out
O
Johndeere 410B 4x4 backhoe wont start since last fall 2023. I have changed fuel filter, manual fuel pump, checked fuel solenoid visibly
Replies
6
Views
365
37chief
3
super99
Roller pump question
Replies
6
Views
750
rustred
rustred
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top