powershift

Steveeberly · Jan 21, 2017

We have a 69 power shift 4020. Where do warren e tap into
The hydraulics to feed the loader hydraulic box and not starve overall supply

JD Seller · Jan 21, 2017

Easiest is to just tee the elbow feeding the oil to the three point right at the rockshaft housing.

JMS/.MN · Jan 21, 2017

I had an older 4020, don"t remember a Tee at the rockshaft, but on my 3020 I replaced the elbow in front of the brake pedal with a Tee, and fed the valve with that. It"s the same line, just a different end.

long green line man · Jan 21, 2017

Locate pressure oil line at priority valve [ under dash cowl , right side] tee can be attached at valve end or rockshaft housing under metal floor deck, but line will need cutting or reshaping ( We replace most with good quality 3000 + psi hyd. hose..) Return line should be att. to rockshaft return line [left side tran. case].. much cheaper than ported filter cap.. safer than drilling & taping filter housing... Pic. is of syncro / powershift will not need elbow , just tee..

long green line man · Jan 21, 2017

Your '69' 4020 with side console hyd. controls will not have an elbow [that can be replaced with tee ] on either end of hyd. line to rockshaft, as early models have, at below brake pedals ,or at rockshaft control valve...

long green line man · Jan 21, 2017

Hyd. line is under platform ; Another way is to purchase a power - beyond block to install at rear hyd. valve..

used red MN · Jan 21, 2017

Hopefully you know this, the loader valve must be set up for closed-center operation. So when the valve is NOT flowing oil to a loader cylinder or is centered it is basically blocks flow to the valve. Open center allows oil to be pumped in a circle under no pressure.

powershift

Steveeberly

New User

JD Seller

Well-known Member

JMS/.MN

Well-known Member

long green line man

Member

long green line man

Member

long green line man

Member

used red MN

Well-known Member

Similar threads