Hello just wanted to ask a question I was lifting a bale of hay today with my jd 1020 went to set bale down handle for the lift broke off at spot weld.I put vise grips on what little metal that was left coming thru the bracket set bale down but ended up grounding metal to where they don't grip to raise or lower lift vise grips wont bite enough metal it just slips.This has 7 inch rod or so extending from housing that runs thru bracket sleeve .What would be my best opion to fix.Thanks.
- Thread starter poppin_j
- Start date
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
You either need to weld tab back on control rod(key 5) or replace it which requires R&R of rockshaft housing . You could try a salvage yard as JD new part is pricey.
AT19838 ARM W/SHAFT ADD 146.57 USD
Thanks for the info TX Jim. I drilled old spot weld out of bracket handle and tried to spot weld handle back on with wire welder but broke,only about 1/8 or so of control rod extending thru rod and lift bracket,may try to grind rod bracket down some to get more to weld on and try with stick weld. Thanks for your reply TX Jim.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy