year around q1 cab installation instructions

I wouldn't think it's too terribly difficult. If you've got the mounting brackets to fit a 3020, it should be as simple as dangling the cab over the operators platform, lining up the holes, and inserting some bolts.
 
(quoted from post at 09:05:21 11/23/16) I wouldn't think it's too terribly difficult. If you've got the mounting brackets to fit a 3020, it should be as simple as dangling the cab over the operators platform, lining up the holes, and inserting some bolts.

Not exactly but not Rocket scientist level either as there are filler plates that must be installed around tractor floorboard after cab is in place. Factory fenders must be spaced wide enough or removed to accommodate the cab. It's been many yrs since I sold & installed Year-a-round & Hiniker cabs and this brings back "old memories".
 
I have no idea where you can find the instructions but when I bought one a few years ago for a 1206 Farmall it was easy enough to figure out.

Rick
 
Think of it as a 3 dimensional 'jigsaw' puzzle. Shouldnt be hard to figure out since most pieces will fit in one place.
 
I have original installation instructions for a QT year-around tractor cab. wiring diagram-plumb in heater
coolant. can copy-mail. 9524665722..
 
(quoted from post at 10:46:44 11/27/16) I have original installation instructions for a QT year-around tractor cab. wiring diagram-plumb in heater
coolant. can copy-mail. 9524665722..

Jim, I need to know how to plum in the heater for one that we are installing on a Farmall 706 gas that we just got yesterday. Is it possible to scan them?

Thanks

Rick
 
RICK-------706 gas; coolant pressure from tee at temperature gauge hole and return to plug at right side of water pump....
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top