(800) 853-2651
SHOP NOW

ford jubilee 3 pt

R

randy1

Member
i have jubille I use to move 4x4 round bales I have to remove acorn nut on right side alot and press in on valve
to get the 3pt to go up then it works good for a little bit then drops bale to the ground and wont repick iam running hyd fluid in the hydraulic section (middle) of tractor.what can my proublem be?
thanks
 
You may want to repost your question to the ford or Ford N. When I had hydraulic issues with my jubilee, the boys there were very helpful. I'm not sure why pushing in on the nut helps. Been a long time since I've worked on my 3 pt. I remember removing the lift cover and I had to remove the acorn nut. My follower pin was worn out along with most of the linkage under the lift cover rusty and excessive wear. If you have to remove the lift cover, buy extra lift cover gaskets. I had to remove my lift cover 5 times before I got it right. Good luck.
 
Acorn nut as in the one on the control handle?? I'll almost bet the control valve inside is sticking and then in turn the control handle is slipping on the shaft. I'd pull the inspection cover and then watch what is going on inside as you move the control.
 
You must log in or register to reply here.

Similar threads

F
1155 Massey 3 pt lift problems
Replies
2
Views
170
used red MN
U
F
1155 Massey 3 pt lift problems
Replies
11
Views
754
old 1100
O
2
Jubilee 3 pt not enought lift??
Replies
7
Views
403
2wheelgnnr
2
M
5525 rear 3 pt erratic operation
Replies
0
Views
119
MARK ROBKE
M
A
Ford 601 series - 3 pt pulses
Replies
5
Views
797
riveroadrat
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top