(800) 853-2651
SHOP NOW

farmall super h?

H

hotrodfun1

New User
Hi this is my first post I am new to this site. My question is how is the best way to tell what year it is? I have a 53-54 super h? the tag says model SH
serial no.7230 J
the block number is C-164
Also is the MW Clutch original? to this tractor?
Thanks for any help
 
Should be a 1953. The M&W clutch was an option, usually dealer installed when new,but could have been added any time in it's working life
 
Somebody tell me if I'm right or wrong. Didn't the 53 have the battery under the gas tank and the 54 had it under the seat?
I'd always been told that was the way to tell the difference.
 
My '53 'stage one' Super H has the battery under the gas tank,and belly pump. The SN is 23**The later 'stage two' has the battery under the seat and live 'mag' pump
 
Thanks for the help. It does have the battery on the left side below the fuel tank. Still the 6 volt system also. Can anybody tell me info on the MW Clutch should I leave it or take it off? and if I leave it what is the advantage? also if I remove it what would I need to replace it with? Thanks
 
The M&W clutch is NOT factory but is desirable to have if it works. Allows one to pull that hand lever and stop the motion of the tractor while maintaining power to the PTO shaft. Very useful for baling, a pull type combine, or any other PTO powered where you need to stop yet keep power to the PTO.

To do away with it you would need to replace with factory parts from a junkyard or hillbilly bolt it together in some way if it is faulty. I would try to find parts for it if it does not work correctly. Some things are available and some are not.

If you have not realized it yet; When you push the foot clutch on a super h both the travel of the tractor stop as well as stopping the power to the PTO shaft.
 
The one problem I am having is there is no handle to pull I see where there was one at one time but it is gone. the clutch seams to work fine. I have not figured out how to run the pto or tried to figure it out yet. I want to make sure everything is in place before I brake something. I have tried looking at pictures of it all together and can only see that I am missing the handle I think? If anybody has a good picture of it all together would be great. Thanks Again for all the great help.
 
I have the original owners manual for the M&W hand clutch. The handle is just a piece of threaded rod, about 1/2" diameter, wtih a black plastic knob on the end. not too hard to make one.

Gene
 
Use the search feature on this site (and most importantly search the archives). Many scans have been posted over the years may find what you need.
 
You must log in or register to reply here.

Similar threads

C
Farmall H or M
Replies
10
Views
464
onefarmer
onefarmer
super99
Super H
Replies
5
Views
271
Check Break
C
E
1940 farmall H trany whine after rebuild
Replies
12
Views
624
Janicholson
Janicholson
RedWhiteandBluewoodlaunch
Early Farmall Super C serial number tags
Replies
1
Views
215
Tom RS
T
S
Super H Serial# Code
Replies
2
Views
194
State of Jefferson
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top